Zanussi ZVM64N Manual do Utilizador descarregar pdf (Página 7)

tions. Use a special cleaning agent for

glass ceramic or stainless steel.

2. Clean the appliance with a moist cloth and

some detergent.

3. At the end rub the appliance dry with a

clean cloth.

Troubleshooting

Problem Possible cause Remedy

You cannot activate or operate the

appliance.

The appliance is not connected to

an electrical supply or it is con-

nected incorrectly.

Check if the appliance is correctly

connected to the electrical supply

(refer to connection diagram).

Problem with the house electrical

system.

Examine the fuse in the electrical

system of the house in the fuse

box. If the fuses blow again and

again, speak to qualified electri-

cian.

The residual heat indicator does

not come on.

The cooking zone is not hot be-

cause it operated only for a short

time.

If the cooking zone operated suffi-

ciently long to be hot, speak to the

service centre.

If you tried the above solutions and cannot re-

pair the problem, speak to your dealer or the

Customer Care Department. Give the data from

the rating plate, three-digit-letter code for the

glass ceramic (it is in the corner of the cooking

surface) and an error message that comes on.

If you operated the appliance incorrectly, the

servicing by a customer service technician or

dealer will not be free of charge, even during

the warranty period. The instructions about the

customer service and conditions of guarantee

are in the guarantee booklet.

Installation

Warning! Refer to the Safety chapters.

Before the installation, note down the

serial number (Ser. Nr.) from the rating

plate.The rating plate of the appliance is

on its lower casing.

ZVM64N

949 594 267 01

58 PEE 11 AO

ZANUSSI

220-240V 50-60Hz

6,0 kW

Built-in appliances

• Only use the built-in appliances after you as-

semble the appliance into correct built-in

units and work surfaces that align to the

standards.

Connection cable

• Use the correct mains cable of type H05BB-

F Tmax 90°C (or higher) for a single phase or

two phase connection.

• Replace the damaged mains cable with a

special cable (type H05BB-F Tmax 90°C or

higher). Speak to your local Service Centre.

7

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários