Zanussi ZGG35214XA Manual do Utilizador

ENUser manualGas hobZGG35214

Disconnect the appliance from the electricalsupply before you do cleaning or maintenancework.Warning! For safety reasons, do not cleanthe appliance wi

Problem Possible cause RemedyThe flame is blow out immediatelyafter ignition• Thermocouple is not heatedsufficient• After lightning the flame, keepthe

Hob recess dimensionsWidth: 270 mmLength: 490 mmHeat inputRapid burner: 3.0 kWAuxiliary burner: 1.0 kWTOTAL POWER: G20 (2H) 20 mbar = 4kWG30 (3+) 28-3

13www.zanussi.com

14 www.zanussi.com

15www.zanussi.com

www.zanussi.com/shop 397226501-A-092012

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4Product description _ _ _ _ _ _ _ _ _ _

and that it is centrally positioned on the ringsin order to avoid safety risks.• Do not use unstable cookware or cookwarewith damaged bottom. There is

• Disconnect the appliance from the elec-trical supply, before you do the mainte-nance work or you clean it.• The electrical mains terminal is live.•

edges of the hob is 400 mm. If it is fitted below400 mm a space of 50 mm must be allowedfrom the edges of the hob.For appliances installed in the Repu

4. With a thin screwdriver, adjust the by-passscrew position.11 The by-pass screw– If you change from natural gas G20 20mbar to liquid gas, fully tigh

There must be no cut or stray strands of wirepresent. The cord clamp must be correctly at-tached on the outer sheath.Warning! Make sure that the cut o

Product descriptionCooking surface layout1231Rapid burner2Auxiliary burner3Control knobsControl knobsSymbol Descriptionno gas supply / off posi-tionSy

Warning! Do not keep the control knobpushed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it i