Zanussi EC 31 Instruções de Operação descarregar pdf (Página 19)

With regard to the protection against overheating

of surrounding furniture surfaces this appliance

corresponds to type Y. This appliance or thebuilt--

in cupboard for the appliance respectively may be

located with therear wall andoneside walltowha-

tever high walls or furniture respectively and with

the other side to another appliance or furniture of

the same height as this appliance.

Hob installation

D Cut out the worktop with the cut--out size as sta-

ted. The toleranced sizes must not be exceeded..

Saw exactly at the marking line. Recommenda-

tion: Mark the cut--out with a steel needle.Cover--

glue the line in order to avoid splintering of the

coating when cutting.

D Clean the worktop in the cut--out section

D With tiled worktops the grooves within the contact

area of the cooking area must completely be filled

up with groove material.

D Then fasten the catch springs with screws in the

cut--out at the marked position. The distortion of

the springs serves as a stop on the worktop.

D With natural, artificial stone, or ceramic plates the

springs can be glued in with special adhesive

(synthetic resin, two--component adhesive, etc.)

D The cooking area is entered from the top into the

cut--out section, centered and firmly pressed on

until the springs will catch.

D Check the seal in the supporting frame for perfect

seating and gapless support. Please do not apply

further silicone sealing matter as this will compli-

cate the removal of the hob if servicing is neces-

sary.

sealing

frame

ceramic glass plate

snap--in clamp

worktop

1 2 ... 14 15 16 17 18 19 20 21 22 23

Sem comentários

Zanussi EC 31 Instruções de Operação Página 19