
Residual heat indicator
Warning!
The risk of burns from
residual heat!
Operating instructions
Activation and deactivation
Touch for 1 second to activate or deactivate
the appliance.
Automatic Switch Off
The function deactivates the appliance
automatically if:
•
All cooking zones are deactivated
.
• You do not set the heat setting after you acti-
vate the appliance.
• You spill something or put something on the
control panel for more than 10 seconds, (a
pan, a cloth, etc.). The sound operates some
time and the appliance deactivates. Remove
the object or clean the control panel.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deactivates.
See the table.
The times of Automatic Switch Off
Heat setting
, - - -
The cooking zone
deactivates after
6 hours 5 hours 4 hours 1.5 hours
The heat setting
Touch to increase the heat setting. Touch
to decrease the heat setting. The display
shows the heat setting. Touch
and at the
same time to deactivate the cooking zone.
Power management
If you set the heat for the cooking zones higher
than the maximum power level, the Power man-
agement function temporarily decreases the
setting for some of the zones. The display
shows the initial heat setting and then the re-
duced heat setting. The last zone you set does
not change.
Activation and deactivation of the outer
rings
You can adjust the surface you cook to the di-
mension of the cookware.
To activate the outer ring touch the sensor field
/ . The indicator comes on.
Do the procedure again to deactivate the outer
ring. The indicator goes out.
Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automatic Heat
Up function. This function sets the highest heat
setting for some time (see the illustration), and
then decreases to the necessary heat setting.
To start the Automatic Heat Up function the
cooking zone must be cold (no
in the dis-
1
2
3
4
5
6
7
8
9
10
11
0
123456789
7
www.zanussi.com
Comentários a estes Manuais