Zanussi ZGF782CX Manual do Utilizador

GAS HOBZGF 782 CINSTRUCTION BOOKLETPlease read this instruction booklet before using the applianceGB

10InstallationIMPORTANT: This hob must be installed by acompetent person to the relevant Gas Standards.Any gas installation must be carried out by aco

11FO2564FO 20443Dimensions are given in mm.Building InBuilding over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawer itwill

12Electrical connectionsAny electrical work required to install this hobshould be carried out by a qualified electrician orcompetent person, in accord

13Fault FindingPreliminary Electrical SystemsCheckA. EARTH CONTINUITY CHECK - Appliance mustbe electrically disconnected - meter set on Ω(Ohms) x 1 sc

14Ignition System / Gas IgnitionYESCheck plug top fuseandreplace if necessaryCheck polarity andearth continuity ofsupply pointCheck earth continuityof

15CommissioningWhen the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below.- T

16Guarantee/Customer ServiceStandard guarantee conditionsWe, Zanussi-Electrolux, undertake that if within 12 months of the date of the purchase this Z

17This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the periodspecified in the appliance

18

19

2Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. If you needassistance, contact our Customer Ca

35669-7309 10/07Grafiche MDM - Forlwww.zanussi-electrolux.co.uk

3For the UserContentsFor the InstallerImportant Safety Information 2Description of the Hob 4Operation 5Maintenance and Cleaning 5Something Not Working

41. Auxiliary Burner2. Semi-rapid Burners3. Ultra-rapid Triple-crown Burner4. Rapid Burner5. Control knobsDescription of the Hob214325

5Maintenance and CleaningOperationHob burnersTo light a burner:z push in the relevant control knob and turn itanticlockwise to maximum position;z then

6Cast Iron Pan SupportsThe hob has cast iron pan supports.Take care when removing them. They are very heavy andcould damage the hob or your kitchen fu

7Something Not Working?If the hob is not working correctly, please carry out the following checks before contacting your local Zanussi ServiceForce Ce

8OVERALL DIMENSIONSWidth: 680 mmDepth: 510 mmCUT OUT DIMENSIONSWidth: 560 mmDepth: 480 mmSUPPLY CONNECTIONSGas:R 1/2 inch (1/2 inch male) Rear right h

9Important safety requirementsThis hob must be installed in accordance with the GasSafety (Installation and Use) Regulations (Current Edition)and the