Zanussi ZGF980ITX Manual do Utilizador descarregar pdf (Página 8)

Lighting the burnersLighting the burners

Lighting the burners

For easier lighting, proceed before

putting a pan on the pan support.

To light a burner:

z turn the relevant knob anti-clockwise to

maximum position (

), then push it

down to ignite the burner.

z Upon ignition, keep the knob pushed

down about

5 seconds. This will

allow the "thermocouple" (see Fig.1 -

letter D) to be heated and the safety

device to be switched off, otherwise

the gas supply would be interrupted.

z Then adjust the flame as required.

If the burner accidentally goes out, turn

the control knob to the "off" position

and wait for at least 1 minute before

trying to light the burner again.

If you cannot light the flame even after

several attempts, check the "cap"

(see Fig.1 - letter A) and the"crown"

(see Fig.1 - letter B) are in the correct

position.

To switch off a burner:

z To put the flame out, turn the knob to the

symbol ( z

)

OperationOperation

Operation

Hob burners control knobsHob burners control knobs

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply (“off” position)

there is maximum gas supply

there is minimum gas supply

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1

Triple crown burner

)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comentários a estes Manuais

Sem comentários

Zanussi ZGF980ITX Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZGF980ITX