Zanussi ZGG76534XA Manual do Utilizador descarregar pdf (Página 11)

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).

A

5. If you change:

• from natural gas G20 20 mbar to liquid

gas, fully tighten the bypass screw in.

• from liquid gas to natural gas G20 20

mbar, undo the bypass screw

approximately 1/4 of a turn (1/2 of a turn

for Triple Crown burner).

WARNING!

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the

minimum position.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the

voltage and the power of the local power

supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a correct

plug which can hold the load that the rating

plate rates. Make sure that you install the

plug in a correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown

(or black) phase cable to the

terminal which has a letter "L". Keep

the phase cable connected at all

times.

Connection cable

To replace the connection cable use only the

special cable or its equivalent. The cable type

is: H05V2V2-F T90.

Make sure that the cable section is applicable

to the voltage and the working temperature. The

yellow / green earth wire must be approximately

2 cm longer than the brown (or black) phase

wire.

Building In

600 mm

600 mm

800 mm

800 mm

www.zanussi.com 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários