Zanussi ZGO75524BA Manual do Utilizador Página 1

GETTING STARTED?EASY.User ManualZGO75524BAEN User ManualHobGB

CAUTION! Install the appliance onlyon a worktop with flat surface.POSSIBILITIES FOR INSERTIONThe panel installed below the hob must be easy toremove a

DAILY USEWARNING! Refer to Safety chapters.BURNER OVERVIEWABDCCDABA. Burner capB. Burner crownC. Ignition candleD. ThermocoupleIGNITION OF THE BURNERA

WARNING! Always turn the flamedown or switch it off before youremove the pans from the burner.HINTS AND TIPSWARNING! Refer to Safety chapters.COOKWARE

1. Remove the pan supports to easily clean thehob. Be very careful when you replacethe pan supports to prevent thehob top from damage.2. The enamel co

IF YOU CANNOT FIND A SOLUTION...If you cannot find a solution to the problem yourself,contact your dealer or an Authorised ServiceCentre. Give the dat

OTHER TECHNICAL DATATOTAL POW-ER:Gas original: G20 (2H) 20 mbar 10,6 kWGas replace-ment:G30 (3+) 28-30 mbar 745 g/hG31 (3+) 37 mbar 732 g/hElectric su

Energy efficiency per gas burner(EE gas burner)Left rear - Semi-rapid 59.2%Right rear - Semi-rapid 59.2%Centre middle - Multi Crown 61.7%Left front -

17

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP867345849-A-322018

• NEVER try to extinguish a fire with water, but switch off theappliance and then cover flame e.g. with a lid or a fire blanket.• CAUTION: The cooking

SAFETY INSTRUCTIONSThis appliance is suitable for the following markets:GBINSTALLATIONWARNING! Only a qualified personmust install this appliance.WARN

• The information about the gas supply is on therating plate.• This appliance is not connected to a device,which evacuates the products of combustion.

SERVICE• To repair the appliance contact an AuthorisedService Centre.• Use original spare parts only.DISPOSALWARNING! Risk of injury orsuffocation.• C

A B CA. End of shaft with nutB. Washer supplied with the applianceC. Elbow supplied with the applianceConnection to the gas supply should be with eith

Electrical RequirementsPermanent electrical installation must agree withthe latest I.E.E. Regulations and local ElectricityBoard regulations. For your

ASSEMBLY1.2.3.min. 55 mmmin. 650 mm560 mm20+min. 200 mm30 mm480 mm20+min. 600 mm4.50 mm400 mmIf a furniture unit is installed at adistance of 400