Zanussi ZCE610X Manual do Utilizador descarregar pdf (Página 26)

LEVELLING FEET

PENCIL LINE ON THE FLOOR

PLAW VIEW OF THE COOKER

480 mm.

100 mm.

300 mm.

295 mm.

WALL FACE

BACK OF COOKER

SIDE VIEW

OF THE COOKER

BASE OF COOKER

ENGAGEMENT EDGE FOR

STABILITY BRACKET

Fitting the Stability Bracket

(not supplied)

If the cooker has to be installed with a flexible

supply pipe, it is necessary that a stability device is

fitted.

(See safety Requirements: Page 25).

If a stability bracket should be fitted by the installer,

these instructions should be read in conjunction with

the leaflet packed with the stability bracket.

Place cooker in its intended position and level

cooker.

Mark off 295mm (11

") from the right hand side of

the cooker as shown, this is the centre line of the

bracket fixing.

Draw a line 100mm (4") from the front edge of the

levelling feet (see diagram) and remove cooker from

its position. Mark off 480mm (19") back from this

line on the centre line of the bracket to locate the

front edge of the lower bracket.

Fix lower bracket (with two fixing holes) to the floor,

then measure height from floor level to engagement

edge on back of cooker, dimension 'A' indicated in

the diagram.

Assemble upper bracket to lower bracket so that

underside of bracket is dimension 'A' +3mm (1/8")

above floor level. Re-position cooker and check that

top bracket engages into cooker back to a depth of

75mm (3"), as shown in the diagram.

Should the stability bracket currently installed not

allow the cooker to stand correctly, exchange it for

the bracket supplied with the appliance.

FO 0179

1 2 ... 21 22 23 24 25 26 27

Comentários a estes Manuais

Sem comentários

Zanussi ZCE610X Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZCE610X