Zanussi ZCM564NW1 Manual do Utilizador descarregar pdf (Página 17)

How to proceed?

• Unscrew and remove the protective cover at the

back of the appliance;

• Connect the power cord to the terminal of the

cooker according to the table no.1;

• Fix by means of cable clamp;

• Make sure that the connection to the terminal is

matching the network power;

• Remount and screw the protective cover at the

back of the appliance.

Change of gas

Your cooker is foreseen to work with natural gas,

propane or butane. It is not foreseen for butane or

propane air.

For changing the gas type it is necessary to:

• replace the nozzles (hob);

• adjust the minimum level;

• check the gas connection.

Stick the label delivered with the appliance

(spare nozzles, corresponding to the type of gas

used).

Table no.1

Connection type Single phase Tri-phase

Tri-phase Y 3 ph.

+ neutral

Bi-phase Y 2

ph. + neutral

Cable connection to the

terminal plate

1 2 3 4 5

N PE

1 2

3 4

L1 L2

L3L1

4 5

2 3

Network power

230V 3~ / 230V 3N~ / 400 V 2N~ / 400 V

Voltage of heating elements

230V 230V 230 V 230 V

Fusible capacity

20 A

20 A 16 A 16 A

Cable section

3 x 4 mm² 4 x 4 mm² 5 x 2,5 mm² 4 x 2,5 mm²

Specification nozzles

Table no. 2

Cat : II

2H 3B/P

Cons.

Burner

Nom.

power (kW)

Reduced

power (kW)

Gas type

Pressure

(mbar)

By-pass

(mm)

Nozzle

diameter

(mm))

g/h

Rapid

2,60

2,50

2,20

0,75

0,72

0,63

Prirodni plin G20

Butan G30

Propan G31

28-30

0,42

1,13

0,77

181,78

157,11

Auxiliary

1,00

0,85

0,35

0,31

Prirodni plin G20

Butan G30

Propan G31

28-30

0,30

0,70

0,50

72,71

60,70

Replacement of the nozzles

Before any modifications or adapt the

range to a different kind of gas, you must

DISCONNECT the cooker from the electricity

supply and ensure that all control knobs are in

the OFF position, and the appliance has cooled

completely.

Every appliance has spare nozzles for every gas. The

hole of each nozzle is marked on the nozzle,in

microns.

For changing the nozzles:

1. Remove the pan support;

2. Remove the burners;

3. Using a socket spanner 7, unscrew the nozzles

(see figure) and replace them with those required

for the type of gas in use (see table no. 2).

Put in place the burners and the pan supports.

1 2 ... 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

Zanussi ZCM564NW1 Manual do Utilizador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZCM564NW1