Zanussi ZK64X Manual do Utilizador descarregar pdf (Página 33)

When building in ceramic glass cookingareas thefront

cross-rail of the build-in cupboard must be removed in

order to have the heat radiating off escape without any

obstacles.

The space under the hob unit must be closed at all

sides in a way that the lower side of the cooking area

is no longer accessible.

The distance from the hob to the furniture part under

the hob must at least amount to 20 mm. If needed,

please fix an insulation. Drawers must not be located

under a hotplate.

The distance from the hob to a high cupboard beside

right or left must at least amount 55 mm, to the back

wall at least amount 55 mm.

With regard to the protection against overheating of

surrounding furniture surfaces this appliance corres-

ponds to type Y (EN 60335). This appliance or the

built--incupboardfortheappliancerespectivelymaybe

located withthe rearwall andone sidewall to whatever

high walls or furniture respectively and with the other

side to another appliance or furniture of the same

height as this appliance.

Built-in dimensions

The opening in the worktop must correspond to com-

mercialdimensions.The hintsrequired aregiven inthe

dimension sketch.

Built-in

Cut out the worktopacc. to prescribed cutout size. The

tolerance sizes must not be exceeded. Do precisely

saw at the mark line. Recommendation: Mark the cut-

out with a steel needle. Glue something on the line in

order to avoid shattering of the coat when cutting.

With tile--coated worktop areas the slits in the support-

ing area for the cooking area must be filled up com-

pletely.

Clean the worktop in the cutout area

Fromthetoplaythecookingareaintothecutout,adjust

concentrically and firmly press down.

Check the sealing in the supporting frame for perfect

seating and resting without a gap. Please do not apply

additional silicone sealing material, the closure will

make it harder to dismantle in case of need forservice.

6 holes in the bottom of the build--in case are provided

for the screws of the fitting plates.

At first screw on the fitting plates by a screwdriver and

afterwards regularlytighten theplates alternativelyand

diagonally offset

, until the frame of the cooking area is

perfectly laying on the worktop.

Atoostrongand one--sidedtightening is to beavoided!

Electric screwdrivers or pusher airscrews to be exclu-

sively used with slip clutch (setting value 1 -- 1.1 Nm).

Worktop opening:

width: 560 mm

depth: 490 mm

radius: 5 mm

Appliance:

width: 572 mm

depth: 502 mm

heigth : 43 mm

Voltage: AC 230 V 50 Hz/60 Hz

Total connected load: 5,8 kW

572

502

heigth of the hob

43 mm

heigth of frame

over worktop

3mm

Frame measurement

on worktop 9 mm

Measurement of

hobs frame

ceramic glass plate

fixing clamp

worktop

1 2 ... 28 29 30 31 32 33 34 35 36

Comentários a estes Manuais

Sem comentários

Zanussi ZK64X Manual do Utilizador Página 33

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZK64X