Zanussi ZCM661NX Manual do Utilizador descarregar pdf (Página 6)

Control knobs on the gas hob

The knobs for using the gas hob of the cooker are

found on the control panel. The regulation knobs could

be turned in anti-clockwise direction until the small

flame symbol, and vice-versa for the larger symbol.

z No gas supply

Maximum gas supply

Minimum gas supply

To light a burner:

For easier lighting, proceed before putting a

pan on the pan support.

1. Push in the relevant knob and turn it anticlockwise

to "maximum position".

2. Hold a flame near the burner.

3. Upon ignition, keep the knob pushed down for

about 5 seconds. This will allow the safety device

("thermocouple" - see figure, letter C) to be

heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

4. Then, check the flame is regular and adjust it as

required.

If the burner does not ignite, turn the control knob

to zero, and try again.

If after a few attempts the burner does not ignite,

check that the burner cap and crown (see figure, letter

A, B) are correctly positioned.

To interrupt the supply of gas, turn the knob in a

clockwise direction to the position "

z".

Do not keep the control knob pressed for

more than 15 seconds. If the burner does

not light even after 15 seconds, release

the control knob, turn it the “off” position

and wait for at least 1 minute before trying

to light the burner again.

When lighting the hob manually (in case of

lack of electricity): Hold a flame near the burner.

Never turn the control knob before approaching the

burner with the flame.

))

)

A - Burner cap

B - Burner crown

C - Thermocouple

The gas burner controls

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comentários a estes Manuais

Sem comentários

Zanussi ZCM661NX Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZCM661NX