Zanussi ZEL640W Manual do Utilizador Página 1

ENUser manualHobZEL640GB

Figure 1L NThere must be no cut or stray strands of wirepresent. The cord clamp must be correctly at-tached to the outer sheath.Connection Min. sizeca

Technical informationHob dimensionsWidth: 580 mmLength: 500 mmHob recess dimensionsWidth: 550 mmLength: 470 mmElectric powerFront left cooking zone 18

• This guarantee is in addition to your statuto-ry and other legal rights.Exclusions• Damage, calls resulting from transport, im-proper use, neglect,

www.electrolux.comAlbania +355 4 261 450 Rruga “Kavajës”, ish-parku autobuzëve,TiranëBelgique/België/Belgien +32 2 7162444 Raketstraat 40, 1130 Brusse

Sverige +46 (0)771 76 76 76 Electrolux Service, S:t Göransgatan 143,S-105 45 StockholmTürkiye +90 21 22 93 10 25 Tarlabaşı caddesi no : 35 Taksim İsta

15www.zanussi.com

www.zanussi.com/shop 397332801-A-332013

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _ _

• Do not operate the appliance by means of an external timer orseparate remote-control system.• Unattended cooking on a hob with fat or oil can be dan

• If the appliance is installed above drawersmake sure that the space, between the bot-tom of the appliance and the upper drawer,is sufficient for air

• Do not put aluminium foil on the appliance.• Do not let acid liquids, for example vinegar,lemon juice or limescale remover, touch thehob. This can c

Before first usePut cookware containing water on each cook-ing zone, set the maximum position and oper-ate the appliance for 10 min. This is to burn o

2. Clean the appliance with a damp clothand some detergent.3. Heat the hotplate to a low temperatureand leave to dry.4. To maintain the hotplates, rub

If there is a fault, first try to find a solution tothe problem yourself. If you cannot find a solu-tion to the problem yourself, speak your dealeror

Make sure that there is a minimum distance of55 mm between the rear cut out edge and thewall.The minimum distance of 100 mm must be leftbetween the si