Zanussi ZCG612J1XA Manual do Utilizador descarregar pdf (Página 14)

COOKWARE

WARNING! Do not put the same pan

on two burners.

WARNING! Do not put unstable or

damaged pots on the burner to

prevent from spill and injury.

CAUTION! Make sure that pot

handles are not above the front edge

of the cooktop.

CAUTION! Make sure that the pots

are placed centrally on the burner in

order to get maximum stability and to

get lower gas consumption.

DIAMETERS OF COOKWARE

WARNING! Use cookware with

diameters applicable to the size of

burners.

Burner

Diameter of cookware

(mm)

Rapid 160 - 260

Semi - rapid 140 - 240

Auxiliary 120 - 180

HOB - CARE AND CLEANING

WARNING! Refer to Safety chapters.

GENERAL INFORMATION

• Clean the hob after each use.

• Always use cookware with clean bottom.

• Scratches or dark stains on the surface have no

effect on how the hob operates.

• Use a special cleaner applicable for the surface

of the hob.

• Wash stainless steel parts with water, and then

dry them with a soft cloth.

CLEANING THE HOB

• Remove immediately: melted plastic, plastic

foil, sugar and food with sugar. If not, the dirt

can cause damage to the hob. Take care to

avoid burns.

• Remove when the hob is sufficiently cool:

limescale rings, water rings, fat stains, shiny

metallic discoloration. Clean the hob with a

moist cloth and non-abrasive detergent. After

cleaning, wipe the hob dry with a soft cloth.

• To clean the enamelled parts, cap and crown,

wash them with warm soapy water and dry them

carefully before you put them back on.

CLEANING THE SPARK PLUG

This feature is obtained through a ceramic ignition

candle with a metal electrode. Keep these

components well clean to prevent difficult lighting

and check that the burner crown holes are not

obstructed.

PAN SUPPORTS

The pan supports are not resistant to

washing in a dishwasher. They must

be washed by hand.

1. Remove the pan supports to easily clean the

hob.

Be very careful when you replace

the pan supports to prevent the

hob top from damage.

2. The enamel coating occasionally can have

rough edges, so be careful when you wash the

pan supports by hand and dry them. If

necessary, remove stubborn stains with a paste

cleaner.

3. After you clean the pan supports, make sure

that they are in correct positions.

4. For the burner to operate correctly, make sure

that the arms of the pan supports are aligned

with the centre of the burner.

PERIODIC MAINTENANCE

Speak to your local Authorised Service Centre

periodically to check the conditions of the gas

supply pipe and the pressure adjuster, if fitted.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comentários a estes Manuais

Sem comentários