Zanussi ZCM5262 Manual do Utilizador descarregar pdf (Página 19)

The appliance ran be connected to the gas

supply, right or left side, by one print of

connection. The end of the distributing pipe is

threaded.

It is necessary to route the connecting hose

(flexible) at the back of the appliance as shown in

the diagram (see fig. 24). Ensure that the rubber

hose is not in contact with any part of the

hatched area shown in the diagram. The hose

has to be fixed in the support by means of the

clamp supplied. The hose should not have

narrow curves or throttlings. Check tightness with

soapy water.

Electrical connection

Important

Any electrical work required to install

this hob should be carried out by a qualified

electrician or competent person, in

accordance with the current regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

Before

switching on, make sure the

electricity supply voltage is the same as that

indicated on the rating plate.

Note:

In case of a direct connection to the mains you

have to interpose an omnipolar switch a

minimum opening between contacts of 3 mm.

The switch should be sited within 2m of the hob

and be easily accessible upon completion of the

installation.

The yellow-green grounding cable has not to be

interrupted by the switch.

Ensure that the supply cord is not in contact with

any part of the hatched area shown in the

diagram (fig. 24).

NOTE: The earth wire should be about 2 cm

longer than the live and neutral wires.

To use cable type H05 RR-F with the section

indicated in the table no.1.

Before connecting check that:

• fuse and household electric installation can

bear the charge of the appliance (see rating

plate);

clamp

connection of

flexible hose

fig. 24

1 2 ... 14 15 16 17 18 19 20 21

Comentários a estes Manuais

Sem comentários

Zanussi ZCM5262 Manual do Utilizador Página 19

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZCM5262