Zanussi ZCV55321WA Manual do Utilizador Página 20

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 19
REMOVING THE SHELF SUPPORTS
To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
2
1
Install the removed accessories in the opposite
sequence.
REMOVING AND INSTALLING THE OVEN
GLASS PANELS
You can remove the internal glass panels to clean
it. The number of glass panels is different for
different models.
WARNING! Keep the oven door
slightly open during the cleaning
process. When you open it fully it may
accidentally close causing potential
damage.
WARNING! Do not use the appliance
without the glass panels.
1. Open the door until it is at an angle of
approximately 30°. The door stands alone when
slightly open.
30°
2. Hold the door trim (B) at the top edge of the
door on both sides and push inwards to
release the clip seal.
1
2
B
3. Pull the door trim to the front to remove it.
WARNING! When you take out
the glass panels the oven door
tries to close.
4. Hold the top edge of the door glass panels and
pull them up one by one.
5. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is complete, install the glass
panels and the oven door. Do the above steps in
the opposite sequence. Install the smaller panel
first, then the larger.
CAUTION! The screen with a printing
on the inner glass panel must face the
inner side of the door.
CAUTION! Make sure that after
installation the surface of the frame of
the glass panel on the screen with a
printing is not rough when you touch it.
CAUTION! Make sure that you install
the internal glass panel in the
appropriate seats.
20
Vista de página 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários