Zanussi ZCV55321WA Manual do Utilizador descarregar pdf (Página 7)

1. Install the anti-tilt protection 317 - 322 mm

down from the top surface of the appliance and

80 - 85 mm from the side of the appliance into

the circular hole on a bracket. Screw it into the

solid material or use applicable reinforcement

(wall).

80-85

mm

317-322

mm

2. You can find the hole on the left side at the

back of the appliance. Lift the front of the

appliance and put it in the middle of the space

between the cupboards. If the space between

the bench cupboards is larger than the width of

the appliance, you must adjust the side

measurement to centre the appliance.

If you changed the dimensions of the

cooker, you must align the non-tip

device correctly.

CAUTION! If the space between the

bench cupboards is larger than the

width of the appliance, you must

adjust the side measurement to the

centre of the appliance.

ELECTRICAL INSTALLATION

WARNING! The manufacturer is not

responsible if you do not follow the

safety precautions from Safety

chapters.

This appliance is supplied without a main plug or a

main cable.

WARNING! Before you connect the

mains cable to the terminal, measure

the voltage between phases in the

house network. Then, refer to the

connection label at the back of the

appliance to use the correct electrical

installation. This order of steps

prevents from installation errors and

damage to the electrical components

of the appliance.

Applicable types of cables for different

phases:

Phase Min. size cable

1 3x6.0 mm²

3 with neutral 5x1.5 mm²

WARNING! The power cable must

not touch the part of the appliance

shaded in the illustration.

7

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentários a estes Manuais

Sem comentários