Zanussi ZCG61046XA Manual do Utilizador descarregar pdf (Página 20)

• it can not get hotter than room temperature,

higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp edges or

corners,

• it's conditions can be easily checked.

When checking the flexible pipe make sure:

• it does not show cracks, cuts, marks of burnings

on the two ends and on its full length,

• the material is not hardened, but shows its

correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not repair the

pipe, but replace it.

The gas supply ramp is on the rear side of the

control panel.

LEVELLING

CAUTION! Remove all the

accessories from the oven.

1. Open the lid of the appliance and disassemble

it.

2. Disassemble the pan supports and all the

burner assemblies.

3. Put the appliance on the sidewall on a clean

and smooth surface. Place each foot into a

separate hole, in the plinth, and rotate it

clockwise.

4. If the floor is not equally flat, use the adjustable

feet on the bottom of the appliance to set a

stable position for the appliance.

To install all the accessories, do the first step in an

opposite sequence.

ELECTRICAL INSTALLATION

WARNING! The manufacturer is not

responsible if you do not follow the

safety precautions from Safety

chapters.

This appliance is supplied with a main cable and

without a main plug.

WARNING! The power cable must

not touch the part of the appliance

shaded in the illustration.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Zanussi ZCG61046XA Manual do Utilizador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Zanussi ZCG61046XA