Zanussi ZGS799ITX Manual do Utilizador descarregar pdf (Página 8)

8

Operation

Hob burner control knobs

The symbols on the knobs mean:

= no gas supply

= maximum gas supply

= minimum gas supply

For easier lighting, proceed before

putting a pan on the pan support.

Lighting the burners

To light a burner, turn the relevant knob

anticlockwise to maximum position ( ) and

push down the knob to ignite.

Do not keep the control knob pressed

for more than 15 seconds.

If the burner does not light even after

15 seconds, release the control knob,

turn it the "off" position and wait for at

least one minute before trying to light

the burner again.

After lighting the flame, keep the knob

pushed down for about 5 seconds. This will

allow the "thermocouple" (Figs. letter D) to be

heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after

several attempts, check the "cap" (A) and

“crown” (B) are in the correct position.

!

When the hob is first installed

Once the hob has been installed, it is

important to remove any protective

materials, which were put on in the

factory.

A - Burner cap

B - Burner crown

C - Ignition candle

D - Thermocouple

A

B

D

C

Triple Crown Burner

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comentários a estes Manuais

Sem comentários