Zanussi ZGG75524LA Manual do Utilizador descarregar pdf (Página 10)

ABC

A) End of shaft with nut

B) Washer

C) Elbow (if needed)

Rigid connection:

Carry out connection by using metal rigid pipes

(copper with mechanical end) (UNI-CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-CIG

9891) with a maximum length 2 m.

Important! When installation is complete,

make sure that the seal of each pipe fitting is

correct. Use a soapy solution, not a flame!

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burn-

er.

3. With a socket spanner 7 remove the injec-

tors and replace them with the ones which

are necessary for the type of gas you use

(see table in "Technical Information" chap-

ter).

4. Assemble the parts, follow the same pro-

cedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass

screw position.

A

A) The by-pass screw

• If you change from natural gas G20 20 mbar

to liquid gas, fully tighten the by-pass screw

in.

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn (1/2 of a turn for

Triple Crown burner).

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• This appliance is supplied with a mains ca-

ble. It has to be supplied with a correct plug

which can hold the load that the rating plate

rates. Make sure that you install the plug in a

correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

10

www.zanussi.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários